From Wikipedia, the free encyclopedia
3D model (Jmol)
|Molar mass||133.341 g/mol (anhydrous)
241.432 g/mol (hexahydrate)
|Appearance||white or pale yellow solid,
|Density||2.48 g/cm3 (anhydrous)
2.398 g/cm3 (hexahydrate)
|Melting point||192.6 °C (378.7 °F; 465.8 K)
100 °C (212 °F; 373 K)
|Boiling point||180 °C (356 °F; 453 K) (sublimates)|
|439 g/l (0 °C)
449 g/l (10 °C)
458 g/l (20 °C)
466 g/l (30 °C)
473 g/l (40 °C)
481 g/l (60 °C)
486 g/l (80 °C)
490 g/l (100 °C)
|Solubility||soluble in hydrogen chloride, ethanol, chloroform, carbon tetrachloride
slightly soluble in benzene
|Vapor pressure||133.3 Pa (99 °C)
13.3 kPa (151 °C)
|Viscosity||0.35 cP (197 °C)
0.26 cP (237 °C)
|C12/m1, No. 12|
a = 0.591 nm, b = 0.591 nm, c = 1.752 nm
Lattice volume (V)
Formula units (Z)
Std enthalpy of
Gibbs free energy (ΔfG˚)
|Safety data sheet||See: data page|
|GHS signal word||Danger|
|P280, P310, P305+351+338|
EU classification (DSD)
|S-phrases||(S1/2), S7/8, S28, S45|
|Lethal dose or concentration (LD, LC):|
LD50 (median dose)
380 mg/kg, rat (oral)
3311 mg/kg, rat (oral)
|US health exposure limits (NIOSH):|
IDLH (Immediate danger)
Related Lewis acids
|Supplementary data page|
|Refractive index (n),
Dielectric constant (εr), etc.
|UV, IR, NMR, MS|
Except where otherwise noted, data are given for materials in their standard state (at 25 °C [77 °F], 100 kPa).
|(what is ?)|
Aluminium chloride (AlCl3) is the main compound of aluminium and chlorine. It is white, but samples are often contaminated with iron(III) chloride, giving it a yellow colour. The solid has a low melting and boiling point. It is mainly produced and consumed in the production of aluminium metal, but large amounts are also used in other areas of chemical industry. The compound is often cited as a Lewis acid. It is an example of an inorganic compound that "cracks" at mild temperature, reversibly changing from a polymer to a monomer.
AlCl3 adopts three different structures, depending on the temperature and the state (solid, liquid, gas). Solid AlCl3 is a sheet-like layered cubic close packed layers. In this framework, the Al centres exhibit octahedral coordination geometry. In the melt, aluminium trichloride exists as the dimer Al2Cl6, with tetracoordinate aluminium. This change in structure is related to the lower density of the liquid phase (1.78 g/cm3) vs solid aluminium trichloride (2.48 g/cm3). Al2Cl6 dimers are also found in the vapour phase. At higher temperatures, the Al2Cl6 dimers dissociate into trigonal planar AlCl3, which is structurally analogous to BF3. The melt conducts electricity poorly, unlike more ionic halides such as sodium chloride.
The hexahydrate consists of octahedral [Al(H2O)6]3+ centers and chloride counterions. Hydrogen bonds link the cation and anions. The hydrated form of aluminium chloride has an octahedral molecular geometry, with the central aluminum ion surrounded by six water ligand molecules. This means that the hydrated form cannot act as a Lewis acid since it cannot accept electron pairs, and thus this cannot be used as a catalyst in Friedel-Crafts alkylation of aromatic compounds.
Anhydrous aluminium chloride is a powerful Lewis acid, capable of forming Lewis acid-base adducts with even weak Lewis bases such as benzophenone and mesitylene. It forms tetrachloroaluminate AlCl4− in the presence of chloride ions.
Reactions with water
Aluminium chloride is hygroscopic, having a very pronounced affinity for water. It fumes in moist air and hisses when mixed with liquid water as the Cl− ions are displaced with H2O molecules in the lattice to form the hexahydrate [Al(H2O)6]Cl3 (also white to yellowish in color). The anhydrous phase cannot be regained on heating as HCl is lost leaving aluminium hydroxide or alumina (aluminium oxide):
- Al(H2O)6Cl3 → Al(OH)3 + 3 HCl + 3 H2O
On strong heating (~400°C), aluminium oxide is formed from the aluminium hydroxide via:
- 2 Al(OH)3 → Al2O3 + 3 H2O
Aqueous solutions of AlCl3 are ionic and thus conduct electricity well. Such solutions are found to be acidic, indicative of partial hydrolysis of the Al3+ ion. The reactions can be described (simplified) as:
- [Al(H2O)6]3+ ⇌ [Al(OH)(H2O)5]2+ + H+
- AlCl3 + 3 NaOH → Al(OH)3 + 3 NaCl
- 2 Al + 3 Cl2 → 2 AlCl3
- 2 Al + 6 HCl → 2 AlCl3 + 3 H2
Aluminum chloride may be formed via a single displacement reaction between copper chloride and aluminum metal.
- 2 Al + 3 CuCl2 → 2 AlCl3 + 3 Cu
In the US in 1993, approximately 21,000 tons were produced, not counting the amounts consumed in the production of aluminium.
Hydrated aluminium trichloride is prepared by dissolving aluminium oxides in hydrochloric acid. Metallic aluminum also readily dissolves in hydrochloric acid ─ releasing hydrogen gas and generating considerable heat. Heating this solid does not produce anhydrous aluminium trichloride, the hexahydrate decomposes to aluminium hydroxide when heated:
- Al(H2O)6Cl3 → Al(OH)3 + 3 HCl + 3 H2O
Anhydrous aluminium trichloride
AlCl3 is probably the most commonly used Lewis acid and also one of the most powerful. It finds application in the chemical industry as a catalyst for Friedel–Crafts reactions, both acylations and alkylations. Important products are detergents and ethylbenzene. It also finds use in polymerization and isomerization reactions of hydrocarbons.
The Friedel–Crafts reaction is the major use for aluminium chloride, for example in the preparation of anthraquinone (for the dyestuffs industry) from benzene and phosgene. In the general Friedel–Crafts reaction, an acyl chloride or alkyl halide reacts with an aromatic system as shown:
The alkylation reaction is more widely used than the acylation reaction, although its practice is more technically demanding because the reaction is more sluggish. For both reactions, the aluminium chloride, as well as other materials and the equipment, should be dry, although a trace of moisture is necessary for the reaction to proceed. A general problem with the Friedel–Crafts reaction is that the aluminium chloride catalyst sometimes is required in full stoichiometric quantities, because it complexes strongly with the products. This complication sometimes generates a large amount of corrosive waste. For these and similar reasons, more recyclable or environmentally benign catalysts have been sought. Thus, the use of aluminium trichloride in some applications is being displaced by zeolites.
Aluminium chloride can also be used to introduce aldehyde groups onto aromatic rings, for example via the Gattermann-Koch reaction which uses carbon monoxide, hydrogen chloride and a copper(I) chloride co-catalyst.
Aluminium chloride finds a wide variety of other applications in organic chemistry. For example, it can catalyse the "ene reaction", such as the addition of 3-buten-2-one (methyl vinyl ketone) to carvone:
AlCl3 is also widely used for polymerization and isomerization reactions of hydrocarbons. Important examples include the manufacture of ethylbenzene, which used to make styrene and thus polystyrene, and also production of dodecylbenzene, which is used for making detergents.
Aluminium chloride combined with aluminium in the presence of an arene can be used to synthesize bis(arene) metal complexes, e.g. bis(benzene)chromium, from certain metal halides via the so-called Fischer-Hafner synthesis.
Hydrated aluminium chlorides
The hexahydrate has few applications, but aluminium chlorohydrate is a common component in antiperspirants at low concentrations. Hyperhidrosis sufferers need a much higher concentration (12% or higher), sold under such brand names as Xeransis, Drysol, DryDerm, sunsola, Maxim, Odaban, CertainDri, B+Drier, Chlorhydrol, Anhydrol Forte and Driclor.
Symmetry and dipole moment
Aluminium chloride belongs to the point group D3h in its monomeric form and D2h in its dimeric form. Both forms of aluminium chloride, however, do not possess a dipole moment because the bond dipole moments cancel each other out.
Aluminum chloride is a neurotoxin. Anhydrous AlCl3 reacts vigorously with bases, so suitable precautions are required. It can cause irritation to the eyes, skin, and the respiratory system if inhaled or on contact.
- Haynes, William M., ed. (2011). CRC Handbook of Chemistry and Physics (92nd ed.). Boca Raton, FL: CRC Press. p. 4.45. ISBN 1439855110.
- Aluminum chloride. Chemister.ru (2007-03-19). Retrieved on 2017-03-17.
- Ketelaar, J.Α.A. (1935). "Die Kristallstruktur der Aluminiumhalogenide II". Zeitschrift für Kristallographie – Crystalline Materials. 90. doi:10.1524/zkri.1922.214.171.124.
- Zumdahl, Steven S. (2009). Chemical Principles 6th Ed. Houghton Mifflin Company. ISBN 0-618-94690-X.
- Sigma-Aldrich Co., Aluminum chloride. Retrieved on 2014-05-05.
- "NIOSH Pocket Guide to Chemical Hazards #0024". National Institute for Occupational Safety and Health (NIOSH).
- In contrast, AlBr3 has a more molecular structure, with the Al3+ centers occupying adjacent tetrahedral holes of the close-packed framework of Br− ions. Wells, A. F. (1984) Structural Inorganic Chemistry, Oxford Press, Oxford, United Kingdom. ISBN 0198553706.
- Greenwood, Norman N.; Earnshaw, Alan (1984). Chemistry of the Elements. Oxford: Pergamon Press. ISBN 0-08-022057-6.
- Andress, K.R.; Carpenter, C. (1934). "Kristallhydrate II. Die Struktur von Chromchlorid- und Aluminiumchloridhexahydrat". Zeitschrift für Kristallographie – Crystalline Materials. 87. doi:10.1524/zkri.19126.96.36.1996.
- Olah, G. A. (ed.) (1963) Friedel-Crafts and Related Reactions, Vol. 1, Interscience, New York City.
- Helmboldt, Otto; Hudson, L. Keith; Misra, Chanakya; Wefers, Karl; Heck, Wolfgang; Stark, Hans; Danner, Max and Rösch, Norbert (2007) "Aluminum Compounds, Inorganic" in Ullmann's Encyclopedia of Industrial Chemistry, Wiley-VCH, Weinheim.doi:10.1002/14356007.a01_527.pub2
- Wade, L. G. (2003) Organic Chemistry, 5th edition, Prentice Hall, Upper Saddle River, New Jersey, United States. ISBN 013033832X.
- Galatsis, P. (1999) Handbook of Reagents for Organic Synthesis: Acidic and Basic Reagents, H. J. Reich, J. H. Rigby (eds.) Wiley, New York City. pp. 12–15. ISBN 978-0-471-97925-8.
- Snider, B. B. (1980). "Lewis-acid catalyzed ene reactions". Acc. Chem. Res. 13 (11): 426. doi:10.1021/ar50155a007.
- He BP, Strong MJ (January 2000). "A morphological analysis of the motor neuron degeneration and microglial reaction in acute and chronic in vivo aluminum chloride neurotoxicity". J. Chem. Neuroanat. 17 (4): 207–15. doi:10.1016/S0891-0618(99)00038-1. PMID 10697247.
- Zubenko GS, Hanin I (October 1989). "Cholinergic and noradrenergic toxicity of intraventricular aluminum chloride in the rat hippocampus". Brain Res. 498 (2): 381–4. doi:10.1016/0006-8993(89)91121-9. PMID 2790490.
- Peng JH, Xu ZC, Xu ZX, et al. (August 1992). "Aluminum-induced acute cholinergic neurotoxicity in rat". Mol. Chem. Neuropathol. 17 (1): 79–89. doi:10.1007/BF03159983. PMID 1388451.
- Banks, W.A.; Kastin, A.J. (1989). "Aluminum-induced neurotoxicity: alterations in membrane function at the blood–brain barrier". Neurosci Biobehav Rev. 13 (1): 47–53. doi:10.1016/S0149-7634(89)80051-X. PMID 2671833.
- Aluminum Chloride. solvaychemicals.us
|Wikimedia Commons has media related to Aluminium chloride.|